The Snap-On mini hard handle and pocket screwdriver thread

[Kasal]

¿Alguien tiene uno de estos?

Si lo compré hace unos 2 o 3 años por unos 12 € (14,25 dólares). No sé si es viejo pero lo compré nuevo, increíblemente tengo una tienda cerca de mí que vende Snap on en este lado del mundo, así que si sus productos están en una caja de vidrio cerrada con un candado, recuerdo haber visto el mismas herramientas en los últimos 13-15 años.

 

[Lurch11]

Here are the ones in the shop. Still have a couple sets to finish. The yellow and green are for my kids' sets and the violet is for the missus. She also has the new pink set and I have another orange set at my desk. I have one of those red pocket philips here somewhere too but can't find it.

Also have these...they have a slight "craftsman handle" odor but they were cheap

Can’t find the Mini 12 PAKY anywhere..l

 

[Lurch11]

Been gathering the 4 pack sets for a while. Oddly enough the black and pink ones are the hardest to find in good condition. The blue sets cost the most to obtain in general when I can find them…

 

[jeffmoss26]

Wowww

 

[AJHD]

Wowww

More like... Why?

 

[canuckian]

Can’t find the Mini 12 PAKY anywhere..l

I've never found the proper "Y" box for them either. I think the ones in the picture are in a Mini 12 PAKB box, or O.

 

[s3zau]

A compact pocket ratchet ,based on a SDDDM1A

 

[Lurch11]

Love the compact ratchet, I need one of those for my emergency roadside toolkit for my truck.

 

[AJHD]

A compact pocket ratchet ,based on a SDDDM1A

How can we make one of those?
I would buy it.

 

[KnurledNut]

Not as small as above, but a fairly compact bit ratchet I made:

 

[s3zau]

I took a cheap version of the 1/4” pro-auto ratchet €19,-
and pul the handle of ( very easy to do ,no heating needed)
than I just shortend the handle a little to the snap-on handle dept
than I milled a 1/4” hex on the remaining part .


magnetic retention
I kept the 1/4 “ slightly larger to minimise the play on the holder ( some test fitting) all in all a half hours work

 

[s3zau]

An alternative, you can make a bit ratchet and use a

711L Hex End EDC Ratchet Wrench - Accessary for Multitools with 1/4" Hex Bits Adapters - Compatible with 1/4 Inch Socket Extensions ( no link but it’s available on Amazon.com)​

but I’m not sure the hex part is long enough without modifying it a little to fit the snap-on pocket bit handle

I have ordered 1 to try
Dirk

 

[s3zau]

This is the bit ratchet version

 

[jeffmoss26]

rounded up my custom stuff for a pic. The 4 items on the right were made for me by a former member. The maroon driver I purchased on GJ and the others I modified myself/with help of a coworker several years ago