today's project is conduit bending

[rockwithjason]

i got a project today to install a new feeder to a building. the job requires me to run some 3 inch rigid conduit so i set up the greenlee 884 and went to work. i needed to fab up a 9 inch offset using 15 degree bends. about 45 minutes from set up to complete bends.

 

[skulldrinker]

Looks almost like my old Enerpac which was a segmented bender.

 

[mdkingsley]

Nice work

 

[rockwithjason]

you can get adapters for segment bending but this particular machine is a one shot. thanks for the compliments