paslemeilleur
Member
From a lesser-known German manufacturer: Stecoge 6 & 7mm wrench.
Tools from the old world
- Thread starter Monte
- Start date
NitroExpress
Well-known member
Picked up this set of Hazet reversible ratcheting combination wrenches 8-19mm:
I had Gedore and Snap On handy, so a few comparison shots:
The Hazet are pretty darn nice, I like them better than the Gedore.
I had Gedore and Snap On handy, so a few comparison shots:
The Hazet are pretty darn nice, I like them better than the Gedore.
egfdevos
Well-known member
I have both Gedore and Hazet.
I know that the Hazet reversible ratcheting combination wrenches are made in China.
I always grab the Hazet ones they feel the nicest.
I know that the Hazet reversible ratcheting combination wrenches are made in China.
I always grab the Hazet ones they feel the nicest.
NitroExpress
Well-known member
I believe they are made in Taiwan, not China. This is based on the COO listed on KCTool. I wasn’t able to verify on Hazet’s site.
Last edited:
Qualitytools
Well-known member
The ratcheting end on the Hatzet is smaller and not as bulky as the others. Thanks for sharingPicked up this set of Hazet reversible ratcheting combination wrenches 8-19mm:
I had Gedore and Snap On handy, so a few comparison shots:
The Hazet are pretty darn nice, I like them better than the Gedore.
NitroExpress
Well-known member
Yes, that’s the main reason I prefer Hazet over the Gedore. For me, that’s often the limiting factor in being able to use a ratcheting wrench.
Qualitytools
Well-known member
I think you’re correct however, I have not had any issues with those coming out of Taiwan
There is nothing wrong with the ones from Taiwan. It looks like a lot of reversible ratcheting combination wrenches are from Taiwan. I wonder if the Gedore ones are a bit larger because they use a different design.
Qualitytools
Well-known member
It could very well be. I like the smaller print of the FACOM that I have, it allows me to use the wrench in tighter places.