Vintage Craftsman block grinder

[threeputt]

I was told to post this here. I hope its ok because I did start another post before I saw this topic. Sorry about that but here goes.
I traded for this old craftsman. I need a power cord about 6 foot long.
Model - 397/19390 Design -C2372
It runs nice and smooth .
I could also use a off/on switch
Any suggestions appreciated.
I got many 18 gauge computer cables but not sure they would carry the load ?

 

[lafester]

Amazon sells 14 and 16 gauge cords for cheap, I would go with one of them.

 

[ChefRex]

https://garagejournal.com/forum/showthread.php?t=157794

Here's where you want to go.

 

[threeputt]

Amazon sells 14 and 16 gauge cords for cheap, I would go with one of them.

Thank you. How about the on/off switch. Did you replace yours ?

 

[threeputt]

https://garagejournal.com/forum/showthread.php?t=157794

Here's where you want to go.

Yes, thanks for that info.

 

[lafester]

What about the switch?
I have never really had an issue with mine.

Sent from my SM-G970U1 using Tapatalk

 

[threeputt]

What about the switch?
I have never really had an issue with mine.

Sent from my SM-G970U1 using Tapatalk

I need one.

 

[lafester]

I need one.

Need a pic of the old one.

Sent from my SM-G970U1 using Tapatalk

 

[FrankLee]

On Craftsman grinders and motors, I've used literally dozens of these 16/3, 13 amp power tool replacement cords from HD.

​

and a handful of these 20 amp, 3/4 hp capacity switches from HD.

 

[threeputt]

On Craftsman grinders and motors, I've used literally dozens of these 16/3, 13 amp power tool replacement cords from HD.

​

and a handful of these 20 amp, 3/4 hp capacity switches from HD.

That is the info I needed. They have them in stock and will pick up this morning. THANKS