Two metal cabinets I got for free. I scavenged the 5" solid rubber casters (two are locking) off the red chest, and am going to clean it up, fix it up & sell it. I think it was a storage/display for some automotive assemblies, or parts, like ignition parts. The door is a double piano hinge, w/a missing locking latch, and a male/female spring latch, too. The sheetmetal is a heavy-gauge, the construction is welded, but the (missing) back was fastened in-place with nut-serts. I'll probably replace it with a piece of scrap plywood, the top was already replaced with a plywood piece, and while it was originally red, it's been sloppily brush re-painted. I cut-off the deep piece on the front of the inside shelf, to allow more room for things. I may make a half-shelf inside out of scrap plywood.
The grey chest of drawers is for small parts, the drawers aren't on rollers, there is an exterior bar to hold all the drawers closed, as you move the bar to either allow all drawers to open, or all are barred from opening as the bar moves to hold them closed. It came with several teflon tape rolls, a bunch of crimp electrical terminals, some heavy-duty L-brackets, misc. nuts, bolts, and washers, etc. I'll sand it and spray it, and probably sell them both.
