Recent content by abwehrly42

Anyone else have their order cancelled?

...

Thanks for the chance!

I replaced the glass in a pair of french doors. There is a plastic frame that sandwiches the glass in place. Several of the screws were missing. I found replacements online, but with shipping I am looking at $13 for a handful of screws. Does anyone know of a cheaper source? They are 1.5" in...

https://troyerpostbuildings.com/

I recently purchased this Stanley 610 bench grinder. I believe it was made by Kingston-Conley. The dust shield clamps on to a machined step in the motor case. The arbor is 3/4" with a woodruff key. Is this a suitable candidate to adapt a mutitool attachment to? I imagine I will have to make a...

See attached

Thanks for the information. I was hoping to combine vents to minimize the number of penetrations in my roof.

I would like to add a natural gas heater to my attached garage. I've done a little research and learned the term common venting. Is it possible for the heater to share a vent with my water heater?

I am in a similar situation. I found lots of good advice in this thread and want to get opinions about how to insulate my pole barn. It is 30ft wide and 32ft deep with trusses on 8ft spacing. The walls and gable ends have been spray foamed. The soffits are vented. I like galute's solution in...

Thank you for the information and advice.

I am building a garage with living quarters to live in, with the intention of eventually building a house beside it. I met with the power company about my electric service. They recommended a single 400 amp service running to the shop and then to the house. I will only have one meter and it will...

That is a very nice building Hangar Pilot! How did you handle the building codes for fire between the two spaces? Do you have a copy of your floor plan? Are there any changes you would make if you were to build another?