Recent content by aerobb

Thanks I'm happy with the way it came out. I'm pouring concrete this spring in my barn, and I plan on picking a small area and using Canvas Tarps, the will just roll up to get them out of the way, rather than the plastic, I think the OP is going to re-using his set up so I'd recommend canvas...

A friend of mine and I did just this on my 80 ironhead, I've got some pics, but nothing of the paint booth we set up. Basically we created a area big enough to work with heavy plastic dropped from the ceiling. We used a wall with a window, and in the opposite side, in the plastic we built a...

Hey something I can answer, I haven't used my aerospace degree in years, so here you go. screen would cause the inlet air to have turbulence and reduce the effectiveness of the engine. I can talk about laminar boundry layer theory if you really want to. But then again maybe I've killed those...

I've also got a 30x40 that I'll be plumbing this spring, mine is a barn and does have 2 columns running down the center, so i'll be able to center feed for both bays, and I was only going to have 3 drops, one along the back wall and 1ea. on each column.

Stick with the 2 stage, you'll be happy you did.

600' is a long shot. Yagi's may get you close if both are in bridge mode. 100 meters is the max for 10/100/1000 wired. Fibre ;)

If it's not an extremely rocky soil, I'd ammend what you have. put down a few inches of good organic material, till, rake, seed and roll it. If erosion is an issue, cover it with straw. I haven't tried any of the new hydro-seeding options so maybe I'm just out of date.

Now that's a piece of information I didn't know. I assumed that since there were two bus bars in the Main, that each bar was separate. Thanks for the information, that answers my question

I have two services to my house. It used to have an in-laws apartment, therefore the two services. I always thought they were 100 Amp services, I finally checked tonight and low and behold they're 200 Amp. :bounce: So now I'm going to be able to run the 100 Amps Sub instead of the 60 Amp like...

The only thing I'd add to a great list is that I plan on installing a quick connect airline fitting on the outside of the garage, then hang a short piece of airline with a tire chuck next to the door. Keeps you from having to either pull stuff into the garage to air up a tire, or even to open...

Very nice, the insignia is great, it looks suprisingly familair to the Tatto that's on my chest ;)

Couple of tips, I just got done with doing my house. I used both the perforated and solid soffit. Think about using F channel up agains the house, nailing upside down under the eves can be a pain. Get the hole punch. Don't ever drive a nail directly thru the vinyl, it won't allow for...

I had half of a ~150 yr old hard maple fall on my house a few years back landed on my roof, I got lucky and it only broke a fascia board. Couldn't believe it as it was about 2' in diameter. Was lots of fun clearing off the roof. I hired a guy to take down the other half before my luck ran out.

And how I did mine

Rent a ditch witch and bury it. Otherwise you'll have to worry about it everytime you raise a ladder, or need to get something tall like a delivery truck or backhoe between the buildings.