Recent content by bauer0667

What other information would you need to know? I want to get this right this time. Thank you for your reply.

I also thought about switching to a hot water heater? Any thoughts?

We got hit with the midwest flooding in March and the Cast Iron Crown 105,000 BTU boiler was submerged under water so I'm looking to get a replacement, however i don't know if i should go with the same size boiler or even replace with a water heater. Thoughts? Below are the details. Any advice...

Good morning, I have an older 41ft x 32ft Red Iron Building with 10ft walls and a 12ft peak in South East Nebraska. The walls are the older 12" insulated panels that lock together. It has 6" concrete with 2" foam board insulation under it. There are two 4ftx8ft Pella windows and a glass walk in...

I think i'm going to go with setting up the primary /secondary how do i decided what size circulator's will i need?

If all you have is low temp (radiant is low temp) -- and the crown is not designed for low temp return. You will have to set up a primary secondary piping arrangement. Do you have radiators? what controls the boiler -- outdoor reset? I always use Buderus boilers -- they have the ability to...

Anyone have any experience with a setup like this? The goal is to get the return temp of the boiler above 120 Degrees.

If the heat output rating of the boiler is at least four times greater than the design load of the low-temperature distribution subsystem, the second three-way valve may not be needed. I have a 105,000 BTU boiler and I have been told my heat load would be 28,600. Should I try it with one valve...

Im trying to figure out what circulator pump I need for my radiant floor. I have a 32'x41'x6" concrete floor in an older red iron building with the 12" insulated panels that lock together. The building has 10ft high walls with some Batt insulation and a tin roof. The pex is about 3" below the...

I have a Cast Iron Crown 105,000 BTU boiler hooked up to my radiant floor. Unfortunately my current setup is bringing the return temp back at 90 degree's. Which is 30 degrees to low. I installed a 3 way thermostatic mixing valve thinking that would solve my problem and ended up creating another...