Recent content by Bauschracing1

Airplane spruce should have it Sent from my iPad using The Garage Journal mobile app

If I had put a side jack that spins,I could but I wanted the type that I used. Sent from my iPad using The Garage Journal mobile app

It is finished, registered and tagged Sent from my iPad using The Garage Journal mobile app

There are times that I want to go to the drag strip and just watch racing and visit. It did not make since to use the 24 ft. Enclosed for that. I built a 5x10 trailer for that reason as well as yard work use.. All done except the paint and tag. Sent from my iPad using The Garage Journal mobile app

I built a similar stand with foot pedals. Works good because you are on the same side and both hands are free. Mine are mounted similar to yours and have work d well for most items but can hinder you on others. Sent from my iPad using The Garage Journal mobile app

Retired after 32 years with the Department of Defense and my wife retired after 25 years as a teacher, we decided to move from the city to the country. Wanted enough room for my shop. We built a new house and 30X30 shop. It has 200 amp service, a half bath and a perfectly level 6 inch slab. My...

The tail stock was replaced and one of the main shafts. I was lucky having just installed a reed case ( $900 plus installation) , that kept most everything retained. Sent from my iPad using The Garage Journal mobile app

It’s a 74. Only thing I could think of was not hitting the brakes. It did oil down the track Sent from my iPad using The Garage Journal mobile app

Has a lock that is used on the weight bar to keep the plates from falling off Sent from my iPad using The Garage Journal mobile app

I will tell him Sent from my iPad using The Garage Journal mobile app

Yes plus the ladder bar cross brace helped some. I did install a nice new loop plus a 3 inch driveshaft. The transmission had a Reed case and suffered major damage. Sent from my iPad using The Garage Journal mobile app

Got a great deal on it 2003 club car 48 volt golf cart. After review, the lift kit was not completely installed which caused the frame to crack at some of the welds. The seats were all torn and the wood was rotted. The 6 batteries were hanging down because the aluminum framing was corroded...

The driveshaft broke in half at the 1/4 mile marker while doing 114 mph. It took out the whole floor so patching it was an option. Had to cut out the entire floor at the factory seams as well as the roll bar. Installed the AMD floor plan and added a new 10 point cage. I also added a swing out...

The tractor supply farm paint is great for trailers and is oil based. It holds up well. You have to follow directions and put on each coat and let dry complete before spraying the next. Sent from my iPad using The Garage Journal mobile app

I forgot, you hang on to the grab bar. The weight is locked on the 2 inch rod that is painted black in the picture and the strap is attached to the hook at the bottom. Would be better with two rods ( installed on each side) but I thought about it later. Sent from my iPad using The Garage...