Recent content by BFalfa

what did you use on your floor?

finished blowing in cellulose in my 40x72 shop walls...8" thick took a lot of insulation! now on to the ceiling as soon as I get some tin up!

just got my 7.5hp champion hooked up last weekend..used a knife switch as a disconnect on the wall. and for what its worth I used 6gauge wire and hooked it to the l1 and l2 terminals. works just fine.

i have a Lincoln precision tig225..great machine!

That was my thinkin too...just didnt know if it would harm the floor inside the shop.

hello..i will soon be pouring the rest of the floor in my pole barn/shop and have formed up a small pad 4x8 at the man/walk door. should I drill and tie this small pad with rebar to my existing floor or is this a bad idea? I am located in NE Mo. Thanks.

I have 4 snap on....that is the only 3/8 ratchet that i use.

I should be able to show the coupon on my phone when I go to the check out right?

thanks guys!

looking for the $699 coupon for the 56" lower box.

well...I had to look up what AHJ meant and have no idea what the NEC is..so call me dumb. Iam in the middle of nowhere Midwest.. although I am able to do pretty much whatever I want to on my property, I do try to do things the right way. :) thanks again guys.

I actually do already have the wire ran. thanks for all the help. I think I have it figured out.

The reason for the 2 outlets is that my shop is 40x72. 1 outlet is in my "shop" area and the other is in the middle of the building incase I need to move my welder to that location for a repair. However I do plan to use a beefy extension cord at that receptacle. Thanks guys.

hello. iam running my welding receptacles in my new shop and will have 2 places to plug in my welder. I am using 6 gauge wire with 50 amp receptacles with a 50 amp breaker. I will only be using 1 receptacle at a time. Now my question. since I am running both of these off of the same circuit I...

thanks guys.