Recent content by bobbyjean

scary , rip it all out i would say-what a mess-yes the silver paint is a bonus

sounds like free tire rotation-always running that special on some fluid change you dont need

66hertzclone-the price to run the line seems like it would cover your new boiler(oil) and some of the sidearm heater i would go with for hot water-the oil does need to be serviced each season while gas needs to be checked but is more forgiving. weil mclain is good,burnham ,crown ,peerless are as...

use the three supply hits you already have and add ductless units -not sure of your floor plan...if you are below grade in any of the basement that will be conditioned it should be figured in,is humidity a concern there-go with a name like fujitsu,mitsubishi,daiken for low temp heating...

20 years is pretty good,guessing it was made in the usa then,wonder where the b-vent of today is made.{yes i can look it up but its late and i'm lazy} codes have changed and stainless should last "forever" .............. at three times the cost i think it should$$$$$$

Refrigeration Technologies RT201B Nylog Gasket/Thread Sealant -this works very well

ok,so its option number 3? go with the 80k unit but get a dual stage 95+ this will get you out of an expensive chimney and some energy saving's-lucky dog's :thumbup:

gas fired heater like a big maxx with the wi-fi stat-emerson sensi works well ,if needed on the ac side install a ductless or a window unit...500 for the heater,100 for the stat ,you could go with lp if the gas run to house is to crazy,always best to install yourself if you can-saving the...

downstairs unit is in attic? ok...make the checks mentioned above...if that checks out,check fan-amp draw if possible..maybe a run capacitor

i think ductless is the way to go on your build...maybe go with a two head unit like this/ Fujitsu / F2L18W07120000

hanging unit heater...80% 75000btu ...lp is fine...i have the big maxx 50k for a 30/32/10..keeping it at 40 unoccupied and 55 occupied...sips fuel,works great as long as you don't need ac...your good.

mask up and clean the mice **** out,check heat exchanger for integrity, post model number as mentioned above

85...while occupied? your not asking much...i would make sure its ul listed...never saw one but no reason it wouldn't work

try grainger

did you ever figure this? did you install yourself....think you should have seen baffle's inside the tube..just a guess...good luck with it