Recent content by BrooklynBravest

Tapmatic SPD-5. Made in USA tapping head. Original owner. Well maintained regularly oiled. Works flawlessly. Brand new tap jaws recently installed. ($40) Includes R8 Shank Straight shank Collet wrenches Two Stop bars. Selling because it no longer gets used. Will make any custom stop bar you...

Thanks guys Debating if i go 6L now or 10L I don’t need anything huge but 6L sounds pretty tiny

I’m looking to buy an ultrasonic cleaner to remove grease from bike chains. Is it worth buying a cleaning concentrate for $35 a gallon or is there equally effective, cheaper alternatives?

An ad for this caught my attention. Seems like it would be a pretty sweet tool for spot repairs on welds and whatnot. The tool itself does look a bit cheap though… https://blstrsander.com/

I’ll check it out I have an old 4” made in Japan craftsman that’s built amazing but it isn’t ideal spacing. I’d have to make an adapter plate to tabletop mount it.

Got my Langmuir arcflat table set up today. I’m wondering if it’s a bad idea to mount a 4”4” jaw vise off a bracket in the side of the table? The table is cast, sides are 5/16” top is 3/8” I’m mostly worried about breaking the casting. I don’t go crazy bashing anything on it.

There’s an air cooler by the compressor not shown here.

I’m probably being overly OCD but i moved my plasma table so I moved the air lines. The red square will be the plasma cutter the air has to run to. Currently off that distribution block the red hose goes to the plasma, it used to be a couple feet from it so i have to change it no matter what...

The table is by the door. Part of the table will be used for a tapping arm, a good 2x3 section will get lost to that,

Nieko

10’x18 probably. lol

You are not the target consumer…

My hands. I only keep 24x48 sheets up to 1/4”. If it’s larger it’s usually a small half sheet for a special one off item etc. I wish it was $450 now. Lol

Had no idea a new one even existed. Looks like they stopped including a cover, which i took off mine anyhow. And added a water separator.

lol I’ll keep you in mind. It cost about $3500 to build. (With brand new tooling) And it definitely has its quirks. The tooling was probably $1300.