Recent content by bustdknuckle

All these pics makes me wish that my snapon guy wasn't the worst tool guy in the area. Sent from my SM-G930V using Tapatalk

Never to early to start teaching if they want to learn.

They are made by Apex tools. Can also get them branded Gearwrench.

New christmas present.

The pliers wrench is my vote. If he's anything like my dad, (lifetime farmer) he will forget to charge the light, and use the Screw drivers to jump the starter solenoid or pry bar and ruin them

You guys haven't seen the inside of a semi cab with 2 adults and 2 dogs. Most of the time I put down floor mats and seat covers is for my protection not the car. If it trash I pull a trash can over the dump it. Then blow out or shop vac the small stuff then charge the customer $125 an hour...

Welcome from here in Colorado Springs. The plans look good.

I did, the kit is 6488. My bad.

Here in the next month or so I need to remove the head off my 2008 Ford Explorer with 4.0. I was just wondering if anyone has the tool set and are willing to loan out or sell. Haven't been able to find any used sets. Also if anyone has pointers on removing the front chain and left head please...

Re: The Green Tools **** I have both the snappy and channellock crimpers the channel locks when crimping the connectors seem to slide to the end and the insulation gets cut

Re: FREE GIVEAWAY - Milwaukee M18 FUEL 2763 High Torque 1/2" Impact - Realtoolreviews I'm in

Clean up some and changed oil in both my vehicles.

It's not just the head the whole engine is like that. But idk why. All the 4 cylinder camrys I've seen are tilted.

Got the head back on a camry and got it running. Gotta finish it up tomarrow and get it delivered. O and get paid for it.

It's a krl 761. I have one they made a krl 761b with 2 more drawers Mine is from 1996 if you were wanting to find a catalog with one. On the back upper left is all the info stamped into box