crguy's latest activity
-
Ccrguy replied to the thread Hello, and may I introduce The Blue Meanie.From my years of experience using drill presses, 240 is faster than I like to run drills over 1/2", as well as hole saws in any material.
-
Ccrguy reacted to Oregon rock crusher's post in the thread Please help me identify this vise with
Like.
Looks kind of Parkerish but I think it may be a Millers Falls model 63 oval slide vise. Here is an ebay link to a similar or the same... -
Ccrguy replied to the thread Hello, and may I introduce The Blue Meanie.That's a good old drill press, but you're going to need more speed reduction than that setup to get it down slow enough for much metal work.
-
CYes, it is all original!!!... It is a 6 speed press... The guy I bought it from said where he worked they were getting ready to get rid...
-
Ccrguy reacted to Beerhippie's post in the thread Some Vintage Pipe Wrenches, anyone collect them? with Haha.
Erie Tool Works Pipemaster 24": Needs cleaning. Better get on that: I'll let the scrubbing bubbles do the heavy lifting.
-
Ccrguy reacted to four.cycle's post in the thread Some Vintage Pipe Wrenches, anyone collect them? with Haha.
group shot. I thought maybe I could get some action if I put 'em all up as a lot, but no takers. I'm going to add a couple more to the...
-
CHello all, I joined this board as I recently obtined one of the machines I wanted to be able to complete certain tasks around my home...
-
CI commented tongue-in-cheek. Pure Be dust is indeed hazardous. These BeCu alloys are quite common in industry in many applications and...
-
CPicked up this double-open-end wrench at an antique show today for $15 (if it had been a "flea market," probably would have been $5...
-
CHere is a depth mic I found this morning, in a pile of stuff I got from my Dad's shop after he passed away some 20 years ago. Didn't...
-
CThis originally was in the trunk of a car,the owner said,”You can take it or it go into the junk pile.” So naturally I took it home.The...
-
Cin proccess!!!
-
Cthank you very much everyone for the information, now I understand why there is very little information about this drill the next...
-
CAs someone who's broken their frame in half more than a couple times.... You are correct, that overly notched! OP, you need to add more...
-
CJudging solely from the switch and your metric tape measure, I would say it's an Asian-made model that was sold in Australia or the EU...