Recent content by easlers

That madde a nice looking floor Great Job!

**** did you put top coat on your floor? Just wondering I was tempted not to put mine on. I dont see a glossy finish in the pictures of your floor. Looks great!

That is the benifit of the clearcoat. The clear has a textured non slip additive in it believe me I was almost tempted not to put the clear on but this will be a working garage and I was fearfull of slipping on it. With the top coat its plenty slip proof.

ALI American Lift Institute. They are the people that set the standards for certification. If a lift is not certified I would not care to get under it.They make sure that a lift will safely lift what the capacity says it will. Be aware that there are several good lift manfacuters out there but...

The inconsistant color is I had to grind the entire floor after the rust bullet dried in order to mask for the lines. when you sand the dried rustbullet it reveals a dark gray against a light gray. You will see it unless you were to repaint it after doing the lines.

On the lift it is a challanger lift . MADE IN USA. Its a 10000 lift. Just make sure the lift you buy is ALI approved. I chose this lift because of the arm configuration. Good luck with your lift.

I HAD TO RENT GRINDER TO DO THE 9 FOOT SECTION TO GET THE OLD EPOXY OFF. THE REST OF THE FLOOR ABOUT 30 X 30 I JUST HOSED AND SCRUBBED HOSED OFF LET DRY THEN SWEEP VACCUM AND THEN IT WAS READY FOR THE RUST BULLET. i POURED THE MAIN CONCRETE IN JANUARY AND WAITED FOR WARMER WEATHER TO DO THE...

The back 9 foot section was poured in 2000. I had put an off the shelf epoxy on it because at the time it was just a pole barn. After I retired I decided to pour the rest of the floor and do it in the rust bullet. Not bragging but the limes really make it pop. The lines took 2 coats and a lot...

Justin these pictures you may use if you want. Again I am very pleased with the outcome of the rust bullet and would recomend this product line to any one. Now my walls look like they need reworked. But thanks for tips given and i'll tell everyone about this stuff!

Well as I promised the lines really pop but let me warn those who want to do this its very time consumming. I got the 2 coats of rust bullet down but then I had to let it dry so I could mask off for the lines. I then had to sand the whole floor mask it off (took almost 6 hrs.)then paint the...

I USED THE METALIC GRAY WITH RED FOR LINES WITH CLEAR COAT!

Absolutly! I will be able to walk on it tomorrow. I'll get some shots of it but to me it looks awesome. In fact I was looking at it and found 2 little spots I some how missed with clear coat so I called in today and ordered a quart of the red and a quart of the clear to touch up. I put a chevy...

Thanks Justin I tryed the floor polisher on a small spot way too much. I had an air operated sander and that worked pretty well. I've got the clear coat on. I had a gallon left so I'm waiting for the clear to dry a little and I will give a 2nd coat to the 2 main drive in bays. It looks sharp I...

Justin I got my 2 coats of rust bullet down,dryed then masked off for my lines. by this time base coat had exceeded the window by a day. So I sanded where the lines was going and you were right about the red it took 2 coats. Any way I am now going to have to scuff up the whole floor to put the...

Sorry if this seems like a dumb question but I was just wondering. Doing rust bullet in the gray but before I put the top clear coat on I want to paint lines in the floor. What painters tape is best suited to this. I want nice sharp lines. Ive heard duct tape ,blue tape. but realize the gray...