Recent content by erik a

This will do the DIN ends even though the literature does not mention that specifically. The dies have one end for flare and the other is flat for the DIN. https://www.amazon.com/dp/B01HOXH242?tag=atomicindus08-20 https://m.media-amazon.com/images/G/01/apparel/rcxgs/tile._CB483369110_.gif

yup, cut the bottom off and make a nice wind chime.

I went for the studs and let the cross pieces span between and hold the unit.

I was having a heating problem last winter with my Mr Cool.... Outdoor unit would try to run... shake and shut down. Tried all sorts of things with no success... And then noticed the inside filters were totally clogged. Cleaned them and now everything works perfectly. I have now added monthly...

ditto

Looking for some suggestions for a lumber storage rack. Would like to mount to an exterior CMU wall, which is protected by a generous overhang. My short search turns up very cheap or very expensive options. 16" arms would be ideal... Has anyone found a decent heavy duty system they like? Erik A

Matt... PM sent...

I am looking for brand/type recomendations for air compressor oil ... Manual says non detergent, 30w. Synthetic or mineral make any difference? Erik A

Superstrut.... Erik A

A vapor blast cabinet would have that second carb looking as shiny as the other in no time at all... Erik A

I did mine solo, with assist of an engine hoist... Erik A

My just finished 1942 South Bend 9A... Erik A

If it is like the GE motor on my lathe (which I just rewired), the red and blue are for a reversing motor, using a drum switch. Erik A

Cutting a slot with a Dremel cut off wheel and unscrewing them works like a champ! Super easy. Erik A

Yup Sitting on the locks. I have added a cross piece to help some with the "droop", but doesn't help much. If it were leaking into the cylinder, I'd expect oil level to drop, and then oil would blow out thru the air relief while raising.