Recent content by gball

not sure i'm reading the issue right but... you just want to unsweat some fittings? you do it the same way as putting it together. heat up joint till you can pull the fittings apart. will probably have to use MAPP gas. old joints seem to need more heat to get apart in my experience. use some...

Been a while since i updated. Got the garage all sided and started on the house. Done with that till the spring when i can get the power comp. to change me from overhead to underground service. The meter box and pole is in my way. Got most of the insulation hung and about half the drywall...

Thanks. Slowly getting things in order here. Still don't have all the drywall hung or finished so the more i bring in is just more i will have to move again. Plus i have the mess of siding and other building materials in the way... and the babys toys. Two boxes down, Two more to go. Mess this...

...or the whole lead pulls out in one piece when you try to sharpen with a blade.

So i decided to use the precut rolls of this stuff from Home Depot. Think it was 27" x 6' or close to that. Think it was more like 27 1/2''. A roll was just over $12. I tapped the end of the roll on bench to square it up and cut the length of the roll to the depth of my drawers (deepest drawer)...

i don't know about big money... and depending on what it is or what it is used on, speaking of specialty tools anyways, it may be obsolete or more likely most people wouldn't know what they were looking at. Most of my equipment, tire machine and balancer, two table type lifts, drawers full of...

I was just joking, but that makes it even funnier... OP, from some one that grew up in the area, the best thing to see there is the entrance ramp to the freeway leaving.

Are you saying there is still a business open in Pontiac? .:headscrat lol

if you want to post or email pictures of any (thought to be) motorcycle related tools that you need identified i can probably help out. been working on most makes from Harley to Honda over 20years...plus working for a shop that started as a Indian dealer in 1939... i know my old stuff as well.

Not a football fan but i'll make a guess for a chance at those... Patriots.

nearly every piece of furniture in my little girls bedroom is put together with those. shouldn't be hard to find.

so... did she show any appreciation?

they had them at the Autozone i used to work at. Located in same section as bulk wire and crimp terminals.

After looking through this whole post then looking at the the various racks that can be bought as well as the things that has been used to make some... it hit me. I have a pile of stainless wire shelves from a old freezer laying in the scrap pile behind the barn. Just thought i would share...

Fugio, that stuff that tractor supply has by the roll is awesome. i have a friend that has the whole floor in a loft over his shop done with that. reminds me of the outer floor in a roller rink. the TSC by me doesn't carry it though. think i'm gonna go with rubber or vinyl carpet runner they...