Recent content by GSRinmyCRX

purchased the gun to do my house and my parents and have no more need for it. looking to get 225 shipped. Has some normal scuffs in the paint from use but in 100% working condition. link below for more information https://www.pexuniverse.com/peter-mangone-rb-6-pneumatic-pex-clip-gun Levi

I am starting to plan for finishing my basement and getting the floor sealed is my first step. i dont have any major moisture issues but my dehumidifier runs almost constantly so I'm sure I am getting some moisture from the concrete. I want to seal up the concrete to prevent moisture, radon and...

how about 1/2 inch?

1/2 will give me enough flow for a slop sink and hose bib, its not that long of a run. when I say conduit I mean the grey plastic sch-40 or sch-80 suitable for burying. Levi

Has anyone run pex in conduit to a detached garage. Looking to run 1/2 pex line, It will have long sweeps no elbows. What size conduit have you guys used? Thanks. Levi

looking for a good place to get some replacement tracks for my mini excavator. its a bobcat 328G the track size is 320x52.5x74. Thanks. Levi

looking for a lowes coupon, need to buy a air conditioner. how would i go about getting one? Thanks. Levi

I don't want to deal with nail plates of conduit. I have seen a few references to 1-1/4 inches that the wires need to be from the surface a nail or screw would be applied. that makes me thing if I put it on the i-joist it would be fine. Levi

Can you guys give me some code approved advise for how to run wiring through my I joists with 2x4 strapping in my basement. I have pex heating and my I joists are insulated with rockwool batts so I don't want to run the wiring up in the web of the I joists like it would normally be done. My...

If anyone is in the Christmas spirit that recieved a 10 off 50 coupon by email that doesnt plan to use it please message me the code. I have a few things to get that can break down into ~50 dollar orders. Thanks. Levi

It ends up being cheaper if you get the stubby and the jigsaw with the 2x3.0 battery set. Levi

i picked up the rocket light last night. not a bad light for 100 bucks. Levi

At work we recently installed a booster pump with a tank and pressure switch to use for washing trucks. the well gives the building about 50psi and we need more than that to get the trucks clean. we have the booster pump set up on a 70-90 pressure switch. my maintenance guy tells me the crew is...

sounds like fine tooth reversed will work for me. the vinyl specific blade is 40 bucks and i wont use it ever again after my house is sided. Thanks. Levi

I want to get a blade for my 10 inch chop saw for cutting vinyl siding. What would you guys suggest. Thanks. Levi