Recent content by Huffduf41

You guys rock. Thanks for the help!!!!

Nice, thank you. I’m honestly just trying to confirm that the 30watt I’m installing draw less and therefore the existing electrical is fine to connect to as is.

I want to replace these 200,000 candle power (only know this from owners manual) halogen lights with 30-watt LED cubes and would love to know the wattage of the halogens. Any ideas? I didn’t pull the bulb but couldn’t see any identifier on it. Thanks

Thanks, I shot them an email.

Thanks guys, is it possible without the adaptor? I reached out to Milton Industries but have not heard back yet.

I just stepped on this same land mine. 75’ Reelcraft reel with 1/2”NPT end. Does anyone make a female 1/2”NPT to 1/4” quick coupler? No cares on cost. Thanks!

Yes, as you can see I have the last post on that plumbing forum. The link to the sealant used has expired so not sure what he put over the oakum. The urinal is for the bathroom in my barn.

Hey guys, I ordered this beehive style drain for my Kohler Branham urinal and I’m not sure what to use to fill the gap around the PVC. Thanks!

Winner winner, thank you sir I'll start w/ just dimming the 6 lights at the peak (where I'm installing twice what I need) but would like the option to dim everything (all 12 fixtures) in the room if I want to. This switch will allow me to dim everything w/out buying a separate power module for...

Looks like I'll need a switch capable of a 8.5-Amp load that has the purple/grey wires built right into it. Do you guys have a favorite brand/model? Thanks again

thanks guys, I was trying to avoid it but it looks like I'll **** it up and go the dimmer route.

Going in here...will post lighting pics once I get them all hung. [/url]

Hey guys, My lighting layout calls for three IBE12LMVOLT40K fixtures at the peak in one side. I'm running a radiant tube heater at the peak so this isn't possible. I wired the barn for six lights in the peak (three sets of two on each side of the heater) but the electrical supplier I used for...

I took it all apart and don’t see any broken parts or bad o-rings. Should I just replace every o-ring? Thanks again

This guy went from working perfect one minute to do this: Any idea what I need to check? Thanks