Hi all,
I recently had an asphalt driveway installed. The contractor did a base of 8" modified stone, binder coat 2", and top coat of 2". Everything looks good but I noticed during some light rain last week that one area of the driveway has some small pooling of water. The water sort of flows...
Thanks for the replies! Do any of you have issues with weeds coming through the joints/edges? How often do you need to re-apply the sand in the joints?
Anyone familiar with using pavers for a driveway apron? Is there a certain brand - e.g., EP Henry, Cambridge and/or minimum thickness of paver that would be recommended?
Any installation advice or things to ask contractor also appreciated.
Probably depends on the area you’re in, but if you are set on concrete would estimate around 20k - 25k for the full area inclusive of the asphalt space
Hi, I have noticed a line of cracks/openings on the edge of my bilco doors leading to my basement. Any suggestions on how to best plug this gap to prevent weather, water, critters getting inside? Would this be best applied on the inside or outside?
Thanks for all the responses and ideas. What would be a low cost effective wall option here? Concrete cinder blocks? I assume pouring a concrete curb or other type stone wall is a lot more.
Do you mean building the widened driveway such that it is level where it meets the existing driveway but then pitches down gradually to grade level? The grade of the side yard is about 10-12" below the top of the existing driveway.
Thanks for the responses so far - sounds like due to the asphalt edges being potentially compromised and the drainage issues, a retaining wall could be needed. Are there lower cost alternatives that are just as effective? It is about 30-40 ft in length. Is it just necessary to build the wall up...
Hi all - wanted to get some more opinions on whether a retaining wall is required for an asphalt driveway expansion / widening I am planning. My existing driveway is maybe about 10-12 inches at its peak higher than the side yard where I am intending to have the expanded asphalt driveway. The...
Thanks for the replies so far.
Do you think it’s a cost thing for this contractor? Do they save money by just applying a 4 inch 9.5 coat in one go? Or would it be similar cost for them if I ask for 2 inch base coat, 2 inch 9.5 top coat?