Recent content by Jbizzle

I’m in!

That's awesome!

*****Count me in!, thanks for the opportunity!******

I have the Craftsman T-handle as mentioned previously. I got the 1/4" on Amazon for $15. Just rebuilt a 2 stroke engine and it got plenty of use. Actually built pretty good considering the garbage the have been putting out.

Re: Woof turning 101 Nice tutorial but where does the dog come in? JK since you titled it woof training lol

This is the best idea yet! I'd be in for one. The soft face being bigger than the other end does look weird.

Nice work and welcome to the GJ. Can we maybe get a tour of the shop?

How exactly did you do the floor? You covered in flake first and then put a clear epoxy topcoat on it? What products did you use? How is it holding up to the welding/grinding and moving around of all your equipment?

In my opinion Johnson Bar's are pretty worthless. Does anyone outside of the Air Force honestly use them? That is the only place I have ever seen them. A left handed drill bit will take out 90% of stripped screws. I honestly use a cheap set of Craftsman screw extractors. The kind that you drill...

How bout this? Sealant mixer. Also in the drawer are turnbuckle chains and a wire spoon.

Any plans to offer double sided, soft faced hammers?

I use Pan American and they have served me well. http://www.panamericantool.com

You must have got the ATS email too! I have thought about getting those but can't see a useful situation for them yet.

scsracing what model box is that? You make your own top?

oops, sorry not sure why they post upside down?