Recent content by jfruauff

Material is what about 2000ish. 5000 for labor sounds insane. Unless they grinding floor by hand.

Either. You just want a clean straight edge or it will look bad. I wouldnt worry personally about tying the two pads together. I usually only see that when its a structure going from pad to pad and and pads were done in seperate pours. As long as its a good compacted surface it shouldnt move...

Maybe add something like this? I would saw cut that edge straight then pour new concrete with slight pitch away from door. https://www.amazon.com/dp/B0832QXJVJ/?tag=atomicindus08-20

Any of you guys do any prep in a complete metal garage. Mine is going up today and I am looking to order something for floor asap. I will be using this for my own personal car workshop. I at first was leaning toward just ghostshield 8510 since its spray and use a roll out mat under lift. However...

can you pull off and hook directly to battery to confirm its wiring and not the light?

I looked at that one yesterday actually. I was looking mostly at overhead style but the Amgo seemed like it had a pretty good warranty for the price. Do you have it up yet? Was wondering how it looked quality wise.

I did that. I was asking more if anyone had used any of the two places I referenced.

Looking for a 2 post for my garage. Not looking to spend a fortune cause it will be personal use only so not going to be used to frequently. Heres few I looked into. Anyone got any input? -Eagle equipment there is around 1600 and couldnt find really anything good or bad about them in general...

My 18x 40 metal framed garage should be going up in next few weeks. Trying to figure out last few things. Garage is located in florida. Looking for opinions on following. Garage has roll up door on both 18' sides. 1. Adding and inlet vent and exhaust fan to help circulate and move hot air out...

Thanks a lot. I am in florida so I am doing a lot of research on fans. I am not going with air conditioning cause its for working on my cars so a lot of times car will be running. I am leaning toward wall mounted fans just so it one less thing on ground as I am sure garage will fill up fast. Was...

I am building a 18x40 garage right now. You think one on each side of middle facing the ends would work good? I have garage doors on both ends. I been debating wall fans or floor fans. How loud are they?

Ok thanks I figured so. I'll add one at 10 and 30. Thanks

I just had a 18x40 slab poured for garage yesterday. They knew I was adding a lift so they cut 1 control cut down the middle long ways and also 1 down middle short ways. They did it cause the cut would have been at 10ft and lift is going at 12ft. I am kinda wondering if I should have had them go...

Yes I will wait a at least a month for it to cure before putting a sealer on it . I am talking about the garage rollout rubber mats. A lot of the sites sell them as an option between sealer/epoxy and the hard tiles

Grading for my 18x40 metal tube garage is happening today. Hopefully by first of next week concrete will be poured. Have a few questions. 1. Should I have them do a power trowel finish or brush similar to a driveway? 2. Right know I am leaning toward treating with Ghostshield 8510. Not really...