JuncleJohn's latest activity
-
JJuncleJohn replied to the thread Can/should this oxidation be removed?.What about a wire wheel on a drill with a little elbow grease? John
-
JJuncleJohn reacted to Chuckster in NJ's post in the thread This lathe in NJ will be gone fast with
Like.
I think some of these lonely guys just want to take a "test drive"……… Maybe it’s their hobby. :dunno: Like Jim Morrison said: People... -
JJuncleJohn reacted to Stuart in MN's post in the thread 36x40 Attached Garage / Mudroom Build - Layout Suggestions with Like.
What about storage of stuff like the lawnmower, snow blower, rakes and shovels and garden tools? A separate shed would be best, but...
-
JJuncleJohn replied to the thread Introduce yourself here!.Welcome. Btw: It’s always nice to know your approximate location. John
-
JJuncleJohn replied to the thread 36x40 Attached Garage / Mudroom Build - Layout Suggestions.I’m guessing you must only drive small to mid size vehicles. Three 9 foot wide doors will be a deterrent for future resale as most...
-
JJuncleJohn replied to the thread Help with Steel Barn Siding.When I did the front of my building I had two overhead doors to deal with. One was 18x12 and the other was 10x8. In that situation, I...
-
JJuncleJohn replied to the thread Help with Steel Barn Siding.You may need to compensate for that when you install the first panel so when you get to the end of the wall it works out to where it...
-
JJuncleJohn replied to the thread This lathe in NJ will be gone fast.Btw: I buy and sell on Craigslist quite a bit and have had mostly good results.
-
JJuncleJohn replied to the thread This lathe in NJ will be gone fast.Thanks for letting us know. Way too far away for me, but I was very curious whether it was a scam or not. John
-
JJuncleJohn replied to the thread This lathe in NJ will be gone fast.Yep, still waiting…
-
JJuncleJohn reacted to d.mcfarland's post in the thread Interesting engine stand. What was this for? with Like.
-
JJuncleJohn reacted to poppinjohnnies's post in the thread Interesting engine stand. What was this for? with Like.
You guys are the BOMB! Thank you for your help! That literature is great!
-
JJuncleJohn replied to the thread Interesting engine stand. What was this for?.I wonder if it is designed to be used more vertically (upmost position). Rotate the arm up, then mount the engine so it is easier to...
-
JJuncleJohn replied to the thread What brand are these tools?.Nice score. Congrat’s. John
-
JJuncleJohn replied to the thread This lathe in NJ will be gone fast.Now the waiting… John