Recent content by Kidder02

planishing hammer? Sent from my SM-G935V using Tapatalk

I work at the Tilden mine in Michigan's upper peninsula and I can tell you that just between the mines owned by Cliffs natural resources, at least 3 different types of ore are mined to make pellets to ship to mills. Hematite, Magnetite, and Taconite. Also each of these pellets plants spit out...

Now that's funny. Sent from my XT1254 using Tapatalk

I'm guessing the "gas line" is the lead. The "lead" to the torch is braided and molded into the rubber and the gas flows through the center to help cool it. Seen them setup like this before. Sent from my XT1254 using Tapatalk

Mine looked the same after it was poured. 32'x40' garage. Wife asked what was wrong with the floor. Sure enough, it evened out over a week. Sent from my XT1254 using Tapatalk

The mini maglight sized streamlights are tough to beat. Sent from my XT1254 using Tapatalk

Used to work for a farmer who did this method. Foam board, pex, 4" sand, then concrete. His explanation was that if he ever wanted to drill into the concrete to mount anything, he wouldn't Nick the pex. Shop heated fine. Sent from my XT1254 using Tapatalk

Most rental places have tow behind lifts like this. Way better than a scissor lift for outdoor work. Sent from my XT1254 using Tapatalk

Sent from my XT1254 using Tapatalk

Sent from my XT1254 using Tapatalk

Been poking around here for a couple months. Figured I could share a couple pics of what I've got in the works. House is approximately 2000ft² with a full basement. Garage is 32'x40' with 11'6" ceilings. 2 -10'x10' doors on the front and one 8'x8' door on the right side towards the back...

Join the union as a general laborer. Might have to work a bit, maybe 12 hour shifts from time to time, but if your a good worker its good $$.

4½ is definitely the go to for size for most diy'ers. Depending on what you want to spend, Bosch, Makita, Dewalt, Milwaukee, all good grinders. Metabo is a great grinder.