Recent content by LS1NOVA

Went out the roof. Thanks

I would like to use a horizontal vent and run it out the back of my garage. However, the vent would be about 1' to the left and 3' above the window in the picture. The window is 6' from the inside corner. Is this ok? I am not overly concerned with condensation on the window and it never gets...

Finishing a 32x40 shop with 14ft ceilings. Thinking about using 6 of these units. http://www.contractorlighting.com/8ft-lamp-watt-fluorescent-double-channel-strip-120277-p-176.html Bulbs http://www.contractorlighting.com/fo32t8741-rapid-start-triphosphor-fluorescent-lamps-p-161.html So it...

PM me also.

Peter, what products did you use?

Dug the trench today down 2ft and 3ft at the doorways that will have the snow removed. I used this little beauty! If I was rich, Id definately buy one.

Well, Im going to install 2" XPS around the poles and up to the sill boards and pour the concrete like that. Solid anchoring for the walls then.

I will be pouring a concrete floor in a pole barn soon with radiant heat. What are the opinions on how to do it? Around the poles or up to the poles? 2" insulation either way. It seems like the wall would pull some heat from the slab if the concrete was poured around the poles with the wall...

From my understanding, you need to go down to the frost depth to prevent the slab from heaving. I was told 2ft and 4ft. Dont know which. I got all my radiant stuff from a local guy at cost (yes quality stuff) for $2100 including an electric boiler.

Anyone? Im starting the excavation for the slab today.

Im wondering if I should put the vertical insulation 4ft down to the frost line or if 2ft is sufficient? Also, should I put anything in between the insulation and outside ground? Im in the Minneapolis MN area. Thanks

Im not a pro flooring guy as Ive never done epoxy but Im pretty sure you need at least an acid etch.

I have a Miller Diversion 165. I dont even want a foot pedal after learning with the fingertip control. So nice. Built this stainless turbo kit with it.

Eureka twp will grant a zoning exeption for some small businesses though. It should not be too tough, since I will not change the look of the current property. (no signs or outside equipement). Thanks for the heads up though. Good to hear on the electrical.

Hello all. Great site! I finally joined after browsing here many times. My name is Nathan. Im a small business owner, running a small automotive performance shop out of a 3 car garage. My wife and I have just purchased an acreage with a 40X80 pole building. I will be turning a 32x40 section of...