Recent content by mark_k

Ok, can I just drop the side panel a little, then do some quick set in the joint then tape it off and mud like usual?

It's hard to tell in the picture, but it a flat to about a 45 deg wall.

Here is how the drywall butts up.

Hello, I am trying to drywall the ceiling of my sister's bonus room. It is a cathedral ceiling. I have the flat part that runs the length of the room, now I'm trying to do the angles section between the wall and the ceiling. How do I install this piece? I tried trust putting a piece up and it...

Hello, I am looking to finish around the windows of my garage. The Windows are are in 2x6 walls. Should I take some 1x and frame around or can I just use drywall and giv it that trim-less look? Also I need to replace one of the windows, should I do that be fore or after or doesn't really matter...

Hello, I am looking for cheap options to cool my garage. It is fully insulated with 2x6 studs. I am going to run a outdoor wood furnace for heat, but am looking for cheaper options for cooling. I was thinking a window unit, but think the electrical cost will eat me up. Has anyone used a stand...

I am trying to hang vinyl siding in my garage. I am having trouble hanging the starter strip. I seem to get it either to high or to low. If it's to high, I can't get it to snap in. Thanks

Hello, I am looking for a good high gloss white paint for the garage. Something that will reflect light well. Who makes the best for a garage. Thanks.

I was under the impression that the self stick wasn't usable for corners that you had to use paper or the corner beads for corners.

I am working alone on it and not the best on corners so wasn't sure if it would be better/easier to do short runs over doing the whole thing with one peice.

Hello, I am getting ready to tape the corner joint where the ceiling meets the wall. My question is it is 40 feet long, should I tape the whole 40 feet in one go, or short segments? Thanks

Ok, thanks. I will look at the jam extension.

Hope this makes it a little easier to see what I'm talking about. Should I put drywall where the wood is and then corner bead? Thanks

Hello, I have a question about drywalling around doors in my garage. I have 6" walls and standard doors in it. Should I take and put drywall around the frame and then corner bead all the way around? Thank you.

I am l am looking to install an outdoor wood furnace for my garage. I will not be hooking into a furnace, so for my cold air return, do I just put a small section of pipe, but not running into the garage on the back? Also, how do I run the wire for the tstat? Thank you.