Recent content by Mentalmadness

Is this just a general rule of thumb or based off a table?

Let me start by saying that when I am trying to do something 1. I hate paying people to do something I can do (most likely better). And 2. I research this stuff for hours on end and spend so many of my hours it would have been cheaper just to hire it done. Now with that being said I finally...

After I got out of the way and realized I cant do anything I just stood there and laughed

My holding tank for my oil changes on the lift has a sight gauge on the side so you can see how full it is... was time to empty so hooked up the air hose and well one of the fittings wasnt on correctly and the hose let go under like 30psi.....BOOM https://vm.tiktok.com/ZMJQoANgf/

Ceiling is done, in fact 2 days after we finished this happened...lol

The sad thing ia im done with most things, now i have to remove a ton of stuff to expose the walls

Yes the corners and centers have plywood

Is this working

I guess that is the black board, its a fiber type sheet. Basically they built the walls and they are mostly covered with this and there are a few spots that have plywood (im guessing for strength) and then the whole outside is vinyl sided

Got a question for you all. I have a 40x70 with 12' ceiling shop and I have the ceiling done with steel and blown in insulation. The shop also has 3 10x10 doors. Located in NW Ohio. I have tried to get the walls done but im only one guy. With that being said I have about 3/4 of about 20ft done...