mrVanagon's latest activity

Dunno. These guys have been around for a while. https://www.superbrightleds.com/

The GFCI bottom screws (you show them without wires in your diagram) are the load terminals that will power the 2 receptacles via the...

I like my Lutron Caseta switches .. control from my phone and also set to do dusk light up and off. This starter kit (you need a hub)...

You are going to need to wick the solder out of the four mounting holes and get each leg completely free one at a time, then you can...

A handy person who searched out quality fixtures and lamps could easily DIY a complete system for not a ton of money. In my area, it's a...

How can you guys tolerate lights that have to be replaced every year or two? Crappy plastic junk constantly flowing into landfills. ☹️

Just plug it in and see if you get any nuisance tripping……. "IF" it trips a few times just upgrade the GFI to a new HF type and if it...

i agree. I got out my scope and meter, and even with a filter on the VFD's ground, reducing current on the ground below my meter's...

Perhaps you figured it out in post 1. 120V on the feeding wires, outlet won't power an appliance; replace receptacle.

replace the receptacle. probably has internal damage. bust it open after you replace it and look.

I’d turn off the breaker. You don’t want the electrons escaping.

Hopefully, your insurance will cover the damage, and you will get a new service and a completely new home rewire.

Well good thing thats all the happened may not be connected, but when I was in charge of the facility, any time electrical work was...

If I were the power company I'd be inspecting the houses in the area to make sure the 2012 work was done properly....

32A on a 50A plug is fine (by those numbers, your EVSE is made for a typical Romex wired 40A ampacity circuit). A NEMA 14-50 50A range...