Recent content by Nitsua98

This was very similar advice to what Mac Tools technical support had to say. After removing the black bumper at the end of the slides, the drawers closed fine. There appears to be some sort of manufacturing defect where the bumpers do not sit completely flat on the slide, but rather are...

Hi Keep, Thanks for the reply. I attached photos of the light duty slide (pink bumper) which works perfect. The medium duty slide (black bumper) will not close completely. This is an issue with all of the ones that were sent.

I'm working on replacing all the slides in a Mac MB1500 box. Mac was nice enough to send all new slides under warranty, but I'm finding some of the new slides they sent aren't allowing the drawers to close all the way. In the attached photo, the top three drawers use light duty slides. Those...

Hi Everyone, Ace Hardware has a few good deals on their clearance section right now: Craftsman 21 mm x 3/8 in. drive Metric 12 Point Standard Socket Set 9 pc. https://www.acehardware.com/departments/tools/hand-tools/sockets/2300572 Craftsman 1 in. x 3/8 in. drive SAE 12 Point Socket Set 9...

Hi Everyone, I'm working on a plan for finish the garage in the home my wife and I bought last year. I was working on planning out interior wiring, insulation, sheetrock, etc. However, I noticed several spots on the plywood where it appears water is making it through the cedar siding. The...

Ok, so what do we replace them with? I'd like to get a Quick Jack eventually but $$$$.

Merica!

I have the 1/2 stubby impact which is rated at the same 250 ft lbs. breakaway torque as the 3/8. I removed a tie rod end nut with it yesterday no problem. I have the high torque gun as well which is a bit of a behemoth but can remove (or snap) anything you throw at it. It does hammer a bit...

Don't forget an oil water separator. Sent from my XT1254 using Tapatalk

Save it until your next hazardous waste collection day. Sent from my Nexus 7 using Tapatalk

Never thought there would be a reason to compare Snap On and Harbor Freight, but given the brand new "Daytona" floor jack HF just released, it seems the time as come. The reason for this is they are nearly identical in every way. Look at the below photographs: Looking at the specs add to...

My only concern with race deck is what happens with large fluid spills? Engine oil, etc. Doesn't it all seep down between the gaps in the tiles and make it impossible to clean? Sent from my XT1254 using Tapatalk