Recent content by NORDFORD

Hi all! I inherited my grandpas JET 14M drill press. It’s a custom unit that utilizes a lawn mower transmission to drive it. So - I’ve got speed change by the pulleys and also 3 speeds in the transmission, PLUS reverse! My grandpa was a very handy guy. Heavy equipment mechanic, machinist...

https://www.milwaukeetool.com/products/details/m18-fuel-1-d-handle-ext-anvil-high-torque-impact-wrench-w-one-key/2869-20

It looks like an old CM. Been selling rigging for 25yrs.

Do you have any clamps?

The Milwaukee cordless heat gun is mid at best. Eats batteries and does not get hot enough. It’s one of the few Milwaukee tools I get returned often.

Well Brett, how’d the summer go with the mini split?

Well, nobody. Depending on the rest of the plan, it may not be used in this situation, but it is plenty of other applications where lvl’s are still the better choice.

Having worked with both, I’ll take the LVL’s every.single.time. By the time you sandwich plywood, what are you saving? What’s your time worth? No hunting for good boards with same dimensions. Stronger, flatter, straighter.

Mine too! Norfolk Panther over here…..

This is the most logical and likely correct response. It ***** the auction went low, but finding a Comet fan willing to shell out $70k+ is a very small target. I sympathize with you Randy, and she’s a beaut.

Not a thing. Air hammers hit faster, are an 1/8 of the size and actually designed for the task. Buy a cheapo deluxe air hammer and move on. Or just smack the ball joint with a hammer and it’ll release.

In your opinion, what’s a fair percentage?

Thanks dad.

Lighten up Francis.

Typically, against same sized wedge anchors, they have higher ratings.