Recent content by plow

My air line is piped with CPVC pipe.

http://craig-russell.co.uk/demos/cone_calculator/

^^^^yep^^^^

Actually, the top pic is an older version. I'll post up the newer if you're interested. I revised the cross brace as I cant cut the angle with my homemade dry saw and I added an eve. I have all the metal cut for 6 truss sections. I may add a seventh before it's all said and done.

Maybe this will help. It wasn't designed by an engineer though. I bought the steel pictured below and sketched it out on the floor with soap stone. The tubing is 4" x 4" x 3/16". Base plates are 8"x 8" with 3/4" holes drilled at the corners. Again no engineer was involved. I'm going it on...

Is a 4" slab going to be thick enough?

I was taught that gloves were NOT to be worn while using a bench grinder.

Dig It!!

Subscribed

If you do go with a China made unit, Go to the TP Tools site and get their replacement gun and siphon tube. I think it's about 70 bucks, but well worth the money. The difference is night and day.

Sorry. I thought the motor was NOT running. Reading comprehension fail on my part.

Just a thought, before you replace the motor, Jumper out the reset switch on the back first.

Harbor Freight has them as well. I can't comment on the quality though.

I offered 200 a month ago and he turned it down. I damn sure not going 900. I'm thinking 400 tops unless y'all see something I don't. I was hoping to get the saw, and get it running for 1K.

4" x 4" x 1/4" on 45 Deg.