Recent content by redsled

I y

Reorganized my tool box and made room for this today! It is a friends Chevy wagon that i am going to correct wiring.

I paid 450.00 for it.

Yes it is a 6000#, the tahoe is 2wd weighs 5100#s and that is blue tape to keep the paint off the shiney cylinder. I have a newer manual that rotary sent my just after purchasing it.The manual says: oil line must be bled.loosen swivel fitting on cylinder hose. Jog power unit starting switch...

it is a 6000 # cap

I bought a Rotary Midrise lift a few weeks ago. I cleaned it up painted it. It worked fine with nothing on it even my riding mower went up. I put the corvette on it and it will go up then stop. I then tried to put the Tahoe to see if it was binding low. It will not go up. Any ideas. Jimmy

Thanks for all the replies. Do plan on soda blasting. I have access to one.

I have googled and everything else except called the phone # on the lift. Just not sure how much room is needed. I want to put it as close to the back wall as possible and not sure vehicle locations on it.

I asked this earlier but not a lot of help. I came across this lift from a friend who passed away earlier this year whose spouse asked if I wanted it. It was made by AERO LIFT 9000# two post lift any help with how well it worked parts etc.<a...

I bought this lift today for my shop. It is an 8000# Aero-lift. Has any one heard of them? I posted this on another site too so be kind if you have already read about this. thanks Jimmy

looks to be 24-24 to me:headscrat .Redsled

Welcome from Reynolds Ga...Redsled

That is what we issue at the EMC 320 amp and have them install two 200 amp panels on each side of the 320 meter box. My shop and what he has said he will use this would have been sufficient. Although as everyone knows you can't stop putting things in the shop to play with.

you should always put post in ground 10% of length plus 2feet. and definately pour concrete in bottom to sit them on. Jimmy

I work for the local EMC (for 21 years). What size transformer do you have 10,15,25 or what? Where are you located on the feeding of the line? I would atleast want a 15 kva transformer and #2 triplex. On your end I would put in a 200 amp panelnext to meter and feed the house with a 100amp...