Recent content by Ren Hoek

The reel appears to be solid. I don't see away to separate it. there are 3 bolts that go through the center I take those out and see if that will let me get access to the brake pin.

I have a central pneumatic hose reel. The pull ring attached to the pin that locks the reel broke off (see image), and I'm not sure how to pull it back out. I tried to pull it but I can't grab it. Do I need to dismantle the reel to be able to release the spring that holds it Thanks, Brad

Thanks for the info, the only air tools I have are a needle gun and I would like to get a pneumatic gun. I have a HVLP (harbor freight) gun it's rated 6 CFM @ 40 psi. But my compressor is rated 9.1 SCFM @ 40 psi and 7.1 SCFM @ 90 psi. I'm not sure how these compare SCFM vs CFM.

I can run a 240V circuit if needed, I would like to be able to use a HVLP paint gun, and air tools.

I’m looking to buy a different air compressor; I have an older 25gal horizontal craftsman. I want to get a 30gal vertical. Any recommendations would be great, (and the ones to avoid). I have a limited budget so the less expensive the better. Thanks.

Is parts cleaner solvent a degreaser?

Thanks Frank, can you recommend a source to order from, I'm having a hard time finding a source.

test

I am looking for some replacement bearings for my Dunlap motor model no. 115.7448. The bearings are New Departure 908502. Any help would be appreciated. Thanks

Reassembling my Dunlap motor for my drill press.

Great, thanks for the info.

Here is the motor I'm not sure if it is original.