Recent content by ripper70

Has anyone built a Sandblasting room?. Ive been looking at the Norton blast rooms to put in 1 of my bays but might be cheaper to build my own.

Here is a few pic of the finished shop inside with a few projects:beer:Thanks again everyone on the board!!!

I did everything myself and cost me around 21k including benches, heating, compressor, electrical,everything!

WOW that's a lot of concrete. Nice work!

Oh boy its been along time..almost 2 years since I posted. Ive done 2 nice projects in my shop since I finished it. Ill take finish pics of the shop although there might be some projects in the way...:) tomorrow. This board was great in helping me along the way and want to thank everyone on the...

Nice garage. Im having some old cars and flames air brushed in the black stripe going around my shop soon. Nice to see Oregonians on here :beer: Welcome aboard!

Holy **** that alot of stuff...lol. I thought 2 projects was alot :eyecrazy:

Nice garage! Welcome and post lots of pics. We like pics!:beer:

I love mine! Heats my 30x40 fast and is cheap to run.No problems yet.

i would go t-8s. My buddy has t-5s and they are so bright it almost gives me a headache. Im glad i with t-8s i have a 30 x 40 with 12 ft walls,vaulted cieling and went 4- 32' rows. PLENTY BRIGHT.

i hard wired all mine all 164' of mine

Well its been along time since i posted. I was so slammed with construction for the last 8 months i havent had time to do anything in my shop besides buy a few tools and install a 80 btu big maxx heater. Heres a pic of the heater installed. It looks small but it will cook you right out of the...

can i get a quote on a xpr-10 please. Thanks

i ran the rapid air in my shop, they sell kits that come with aluminum manifolds with water bleeders on the bottom and an outlet. Its kind of like pex, really easy to install. I think regular pex is not rated for oil contaminants as i recall but not for sure about that. check out my build...

We have to use Stainless Steel everything here on the coast. Hot Dipped galvanized works in some cases. Those posts should of had HDG CB66's with the plate being just above finish surface. Are you replacing the posts completely?