Recent content by sofasurfer

So, just what do you do on this forum beside ridicule people?

When that $50 is the difference between no shed and a shed with a couple less studs then the correct answer is less studs. I'm scraping up bits and pieces here and there and if I can find a bunch of bent nails you bet I'll straighten them.

Well there we go. Isn't it amazing the things that people invented, especially back when life was "primitive?

On a website devoted to the old mining town of Rockerville, S. Dakota this tool was shown mounted on display on the side of one of the old buildings.

Thanks guys. Its been fun.

It took me 30 years of generator ownership to get it through my head to run out old gas after two years of non-use and otherwise top off the tank with treated gas every fall. I have always loathed small engines cause they NEVER start until I learned to just care for the gas. I can start mine...

More and more lately I let the generator do the heavy work.

My understanding is that the reason to add a load is to keep the generator magnetized. If thats stupid then edjeekate me. Why do we run periodically with a load? And whats the purpose of changing the load with different wattages?

OMG!!!! I fixed it. :-]

Got a storm coming. I want to run my generac portable 3000w generator to make sure it working dine, to run out some old gas and get some new treated gas through the system. Do I need to put a load on it for about a 30 minute run?

Just had some tires switched between rims on two different trucks. Now when its time to put them back on the truck I find that I can not lift them any more. Heres what I did. Line put the wheel next to the hub and line up the holes best as you can. Make sure the truck is up about 2 inches higher...

I was removing the fill plug on my floor jack when it went "plefff" out across the front yard. Needless to say its gone. There was pressure behind it (does no good to know that now) but how much. Will any plug work? I found some black rubber "corks" at the hardware that may work. Heres a post...

This is the gear that I found on amazon. Don't know if its the same. Looks the same...

I have a 3 ton floor jack made by MVP. The gears that the handle turns do not mesh. The teeth sometimes seem to be able to mesh and at other times they do not mesh, as if the teeth are too short. The gear that attached to the valve in the jack also seem to stick sometimes and spins freely other...

I have no way of knowing those specs. If you look at the link in first post you see that this a a cheap harbor freight winch.