Recent content by Steve Tatalovich

Outside

Radiant manifolds

Another, it only lets me load one at a time from my phone. I ran 3/4" pex in the wall for airline drops.

Another

Here is my new barn. 6" slab, radiant. It's not done but getting very close. Steve

Manifolds

Floor is in!

A few pics.

Gents, Im finally getting to the point where im installing pex in preparation for my concrete. Realizing I only have one shot at this I want to make sure I get it right the first time. Facts: Barn size 3200sq ft Im using a wall hung Lochinvar Knight boiler WHN085 I have two zones, Zone...

Hey guys, I'm getting ready to pour concrete in my barn next week. I was wondering if it's ok to attach the pex directly to the foam board using the staple gun and then put wire down or if I should put wire down and then attach the pex with zip ties. I'm pouring 6" of concrete and would like...

It does in drawing #1.

yes I did, Dan C was my sales guy. PM me if you need specific details. I am very happy with my barn, im in Valpo where are you? Steve

Here is my new tool shed, still a work in progress.

we just painted a new concrete floor at work that had a slick finish. We used 1 part muriatic acid to 4 parts water, use a pump sprayer, let the reaction die, doesn't take long, then mop several times with clean water and allow to dry overnight. We used Sherwin Williams paint, HS1000, and the...

with 6" of concrete I would not worry about parking the dozer over the foam, besides the fact it would mess the concrete up. My neighbor has 6" with 25 psi foam and puts his tri-axle dumps on it, and they have much higher ground pressure than a d3 and they weigh twice as much.