Recent content by sujoe

You might be onto something there. When I was cleaning some of the drawer slides earlier, I actually did see some small plastic bits falling off from the drawers. It definitely seems like they could be part of the slides breaking down. Do you happen to know if Snap-on warranties those internal...

I'm getting a distinct 'clank' or clicking sound from my drawers exactly halfway through opening and closing them. You can hear it clearly in the attached video. It happens right when the ball-bearing slides seem to transition from the inner track to pulling the intermediate track. The drawers...

Oh my god thanks so much guys! It’s a success!

Yes, I removed the sticker and used a 3/16 allen key socket to take the handle out. However, when I wanted to put it on the other side, I realized I couldn't screw those allen screws in. It seems like the thread is either off or damaged. I tried to use a thread checker but couldn't find the...

thanks!

I have this KRL-761 and am planning to switch the sides of the handle. Do I pry open the snap on badge?

Just reporting back on my successful experience.I clamped the SHLFD80 in a vise using a pipe jaw (protected with a towel and paper). I grabbed a 25mm wrench and positioned the open-end around the ratchet bar, leaning it against the hard handle. I then used a rubber-faced hammer to gently tap the...

Thanks for the suggestion! But this is for the comfort grip. I do not know if the boiling water will work with the hard handle.

I want to swap the Power Blue hard handle on my SHLFD80 (1/2" Dual 80 long flex) for a red hard handle. I plan on keeping the old Power Blue handle — it’s in pristine condition; red is just my favorite color.Do hard handles need the hot/boiling water treatment like the soft comfort grips, or can...

Was watching your videos and found you here. Thank you for the videos. I'm a budding toolbox addict too. Do you have a website or facebook page where you sell your stuff?

thanks guys! i got it off by rocking it up and down. if i pull straight, it will never budge.

I'm changing the lock to my MasterCraft tool box top box. The tab doesn't seem to be removable. Any tips on removing the tab? Should I try brute force? Thanks for any feedback in advance!

Brown and Sharpe combination square with the 468 (depth gage) and 465 (height gage) attachments

Sorry to revive this old thread. Is the rustoleum hammered light blue or hammerite light blue closer to the original wilton colors? I'm able to buy both of them in my local stores at this corner of the earth.

Bought these NOS Elora 205 made in West Germany recently. Anyone has any more info on these? Sorry if this has been asked before. i'm new here.