Recent content by tigerbalm2424

Realize this may be a long shot but i know there is a vast amount of knowledge running around on this board. Planning to build a larger sized powder coating cure oven that would potentially be used in my garage (or on driveway). Size is likely to be 5x5x10' long. To make it portable or...

Would like to increase the size of my shed (currently 10x14) but i know there is a line moving the effluent from the septic tank to the mound. The septic tank is about 75-100 feet from the mound so there is a line connecting the two. Is there a simple way to locate where the pipe is ran? Also...

Heater installed and all venting is ready to go through the roof sheathing and shingles. In mn with highs in the low 30s and an inch of snow on the shingles. Good idea to install vent at this point with outside temps? There a way to heat shingles safely to soften them before cutting? Thanks

Dollars wise it is more expensive with the stainless duravent pro cap. Its a higher end home so I am more concerned about looks than cost.

Wow, thanks. I did not know that. Last heater I put in was about 10 years ago and i did vertical. Looks like i need to keep researching. I would like to use the low profile vent if possible.

Says minimum horizontal vent length of 5 feet

Hi - not looking to join an existing vent from a fireplace or otherwise. This is a question about options to vent a 75K NG forced air low profile heater. Obvious options are vertical through roof or horizontal 52" out side wall. Is there any reason why i cant go horizontal but use the "low...

Dito.

Anything you suggest I tell the company other than just showing them? Just concerned they wont see it because its cloudy and wont replace it. Im thinking I should have just busted it out before I called insurance :(

I was recently handed down an old used 96 pontiac bonneville from my father because he doesnt want the extra vehicle sitting around. As soon as i sat in the passanger seat I asked "whats up with the windshield?" He immediately stated that my sister had concerns too and asked to have it...

None :thumbup: Its more just a selling point...

For the last 6 years I have had cabinets running the length of one wall(upper/lower) of my garage. I found myself using the cabinets as a place to pile and/or store and forget about stuff that didnt belong or was never used. I have since gotten rid of the cabinets and reclaimed my floor space...

One step further would be to take a picture of every tool and paste it to the pegboard directly behind the place the tool will be stored. That way when you are done with the tools you konw where they go and if a spot is empty you know what tool is missing.... :headscrat

Re: what did you do in your garage today? Rubbed out a giggity. :rocker:

Deleted.