Recent content by vmusch

  1. V

    Torque Limiting Screw Driver/Allen Wrench?

    Awesome find, I will be looking at them a little closer.
  2. V

    Torque Limiting Screw Driver/Allen Wrench?

    I have a need for a reasonably priced hand held torque limiting screw driver or allen wrench tool. The tool is used by different volunteers while setting up an outside display. The display is set up once a week and taken down 4 days later. Part of the display has Allen Head set screws...
  3. V

    Sun Volt-Ampere VAT 28

    Sun Volt Ampere Vat 28 Tester. I can probably disassemble and ship, buyer pays all shipping and handling cost. Unknown if it works.
  4. V

    Tool Box HOHLOOKS.COM

    :thumbup:
  5. V

    Tool Box HOHLOOKS.COM

    http://hohlooks.com/ Any experience or thoughts.
  6. V

    Need a Roll Up Door

    Steel Door Depot
  7. V

    Move non running vehicles into garage?

    I use bucket on tractor with old tire. I installed two Garage Doors, drive through, so I dont want to push I can pull the vehicle.
  8. V

    LP Gas for shop blower short cycling

    Thanks, so what is the proper term for the situation?
  9. V

    LP Gas for shop blower short cycling

    Correct burners stay on, fan cycles. Yes I will add a simple plenum. I was thinking of just building a plenum about 24 inches tall with large vents? Tall enough?
  10. V

    LP Gas for shop blower short cycling

    Was given a LP furnace that I thought I would set up as a free standing unit to replace my wood furnace. The Trane unit has been sitting in a barn and was full of mud dauber nest. So I cleaned it all out and wanted to complete a test run before installing. Hooked up a fuel line, electric and...
  11. V

    Mice are killing me....

    Cats Cat Population will rise and fall, some times of the year I have 0 other times I have 3 or 4 but they keep the mice down. Barn cats are getting harder to come by, put the word out and someone will offer you some. Drive to the east side of the State I can get you a couple.
  12. V

    Tekton is ridiculous...

    Sold me I am ordering some ratchets today. I need a set to backup my expensive truck tools.
  13. V

    4 post lift

    https://www.derekweaver.com/?gclid=CIaZiuq4tdMCFQ9LDQodXeEBkQ
  14. V

    Painting my 46 Ford pickup

    Lately I call the manufacture or rep directly and get expert advice and answers. I ask for the number from the auto parts stores while they must look it up they give me the tech line I call and get real guidance. Just a thought.
  15. V

    What did YOU pay for sprayfoam?

    Location - MO Size of job - 38'x48'x 14' sidewalls Home/Polebarn/garage - Steel Building Cost - $4800 Thickness - 5-6 inches Type - Open cell Closed Cell quoted 7K
Top Bottom