Recent content by ymurf

Wishing I would have waited and got the lift with the locking mechanism. My lift lifts one side faster than the other but only like an inch or two.

I had the same issue on a few of mine and they held fine.

http://www.bestbuyautoequipment.com/mx-6-2-post-portable-lift-system-dannmar-maxjax-p/dannmarmx-6.htm?trk_msg=32C2TUOI5OHKH31ILKBAAK31H4&trk_contact=AG9RU5KNIBHVK63NHVVLC3I3FK&utm_source=Listrak&utm_medium=Email&utm_term=+Dannmar+MaxJax+MX-6+Portable+Two+Post+Car+Lifting+System+ALI+Certified+6000...

Anyone get one of these yet? Looks like they added automatic lift stops every 3" or so now.

I ordered a set like the one on the right in the picture.

Have had my Maxjax installed for a few days now. I have lifted a 68 mustang, 2001 ford focus and tonight my wife's 2005 Trailblazer. Just not comfortable getting under it yet.Waiting on some jackstands that I ordered. How long before you guys with Maxjax were comfortable getting under your cars...

For me its just a safety feature. My son will be working on stuff and I just feel better having them to stabilize the car when wrenching on it.

Got everything done.Lift works pretty good. It does lift a little higher on one side but only a little over an inch and a quarter. And they said that's in there tolerance. I am going to order a couple of those tall jack stands from Greg smith equipment for added safety. I have lifted a ford...

Got everything hooked up tonight. All I need is the short hose that goes from pump to flow divider which I will get made after work tomorrow. mAnd some AW32 which I will also get tomorrow after work and then I am ready to try it out. It says to use AW32 hydraulic oil or dexron iii trans fluid...

Got my flow divider and quick connects today..Hard to believe that little box has $450 worth of stuff in it.

Well the guy I bought my lift from said he would get the flow divider and send it to me..He said he knew where it was. Since then he wont return my call or texts. Thats what I get for trusting someone from Craigslist. Any way I bit the bullet and ordered the flow divider from Danmarr and should...

My buddy has a cnc plasma cutter and it is awesome.

What jack stands are you guys using with your Maxjax? I think I would feel safer with a couple jack stands but doesn't seem to be a big market for 36-48" jack stands. Or do you work under them without and safety measures?

I have a Craftsman rechargeable with I think 60 led of it. I have had good luck with it.

Drilled the other side tonight and epoxied the anchors in. This time I shoved allot more coffee filters in the hole. Also over filled the holes and the epoxy pushed up to the floor allot except one hole. I am worried about the one anchor. Guess Ill check them to 90# tomorrow night.