Search results

Awhile back my pole barn electric was done to a minimum by the electrician, just enough to pass so the power could be turned on..Now I wish to get some outlets for heat etc installed before it gets to cold. Question is should I go the route as the electrician(in pics) or just run stapled romex...

I posted last fall asking for advice on doing this rough in myself. Well with other things going on I decided to hire it out here recently. Today the rough in was completed by a local company and I'm not happy with how things were done. Especially after spending so much time researching this and...

Posting in here cause I didn't see a category for this .."tools" maybe Anyways I have a Husqvarna yth2448t riding mower..While running the engine during some leaky crankcase inspection I noticed hot exhaust coming from around the pipes so I thought maybe I had some leaky flange...

Have used mine for many years and it finally wont lift anymore..no oil leaks either..Can anyone direct me to a the most useful rebuild kit,..and any advice on the teardown? ...is the rubber plug on the housing a fill only?..looking to get the oil out properly before getting started ..thanks

This 6 outlet adapter by Eaton(good brand right!) ..It plugged into my oultet just fine but it ***** when you go to plug a cord into it..It's like trying to push a clothespin through leather..Im actually oiling the pronges to get use out of it till I find an alternative..bout ready to bust it...

Getting ready for a concrete pour and doing a rough plumb for a bathroom to be finished at a later date..Ive got my elbows and sweep t's laid out in order but I'm unsure about placement of the vent t's..in the pic from L to R is (1st) 2" shower sweep and trap..(2nd)1 1/2" vent t ..(3rd) 3"...

Been to this site many times in the past and always have found good info here so I decided to join up to ask to ask some questions but don't see the category of "plumbing "...do I post in "general discussion "?