Search results

I sealed my brushed concrete driveway with V-Seal 102 in the summer of 2013. IS it recommended to reseal it now (four years later)? If so, what would be the appropriate product? Thanx.

I spilled some epoxy on the driveway while doing my garage. Is there any epoxy remover that I can use without damaging the driveway? The driveway is concrete. I am going to seal the driveway and need to remove the epoxy eyesores first. I saw this product at Lowes, but I am not sure if it will...

I am thinking of going with V-Seal 102 for my driveway (need a low maintenance penetrating product). In trying to determine how much I need, I have been in touch with V-seal, but they have a range of coverage (200-300 sq ft/gal). Well, I understand that it is based on concrete porosity, but what...

I forgot to blue tape the concrete wall blocks near the floor and got epoxy on them. Will I be able to put regular paint on the epoxy or will the paint not stick?

Here's my saga for for future generations: The garage is a new construction about 440 sq. ft. I started out by smoothing the edges of the expansion joint groove with a Kobalt rub brick from Lowes. Swept the floor and blew it out with a leaf blower. The next step was filling in the expansion...

Gene- I think you mentioned it but I wanted to confirm again... HOw long after I put down the VB-5 can I wait to apply Epoxy-coat? I acid etched today and am waiting for the floor to dry overnight.

I was planning on filling in the single expansion joint groove in my new garage with Rustoleum Epoxyshield, before using Epoxy-coat. Is it a good idea to do that or should I abandon the plan and let the groove remain? Will the expansion joint still work if it is filled in with epoxy filler?

This isn't exactly a garage matter, but I don't see any other forum to post this in. My new house will have a brushed concrete driveway. In order to prevent/delay spalling and other wear on it, what would be the type of product to put on it? I've read about acrylic, siloxane, silicate but...

I was reading an old thread from 2008 discussing the type of roller to use- nap, size, etc. I was wondering which of these would be preferable to spread epoxy: Wooster Brush R232-18 1/4-Inch Nap Epoxy Glide Roller Cover, 18-Inch or Wooster Brush R207-18 Mohair Blend Roller Cover 1/4-Inch...

(As the old MC commercial with Ralph Kramden said...) Do people use epoxy coatings on their PT lumber decks instead of staining them? What can of worms would be opened if that were done?

This groove runs the length of the garage back to front, in the center. it is V-shaped and about 3/4 inch deep. The house is under construction, so it is filled with untold crud. Any idea what this is and if I Epoxy-coat the floor, how do I handle this groove?

I called Epoxy-coat last Monday (May 14) for their sample tiles to compare and decide colors (their default colors). Has anyone ordered those before? Any idea how long it takes them to send those out?

I discovered this board a couple of weeks or so ago. I have to say this is the most useful forum I have joined. We are getting a new house built and I'd like to epoxy coat the garage floor (bit less than 500 sq ft) before we move in. I'll probably have quite a few questions in the next couple of...