Search results

I may have mistakenly posted this in a vise picture thread, hopefully this is the correct place for replies. Could use some help dating and identifying this vise. Doing a search here I believe it's a Reed vise. No markings besides 413, and jaw size 4 1/2" weighs 70lbs It would be helpful to...

I just replaced the bottom P seal on 2 of my standard size garage doors, just a straight forward replacement. My 14x14 door has 2 metal plates on each lower corner that holds a wheel and cable. The cables have tension, the cable, and bracket on one side needs to be removed to slide on the P...

I purchased a model XPR-10A 2 post lift, when the vehicle is on the lift it leans to one side. I called BendPak support and told them of the lean to one side. Without the tech investigating further I was told to put the arms together, “if their off, shim one side until their level”. I told him...

I purchased a model XPR-10A 2 post lift, when the vehicle is on the lift it leans to one side. I called BendPak support and told them of the lean to one side. Without the tech investigating further I was told to put the arms together, “if their off, shim one side until their level”. I told him...

I purchased a model XPR-10A 2 post lift, when the vehicle is on the lift it leans to one side. I called BendPak support and told them of the lean. Without the tech investigating further I was told to "put the arms together, if their off, shim one side until their level”. I told him my posts were...

Test

Hello, I’ve been a member for awhile but this is my first post. This is a great forum with knowledgeable members. I have an old compressor a 1967 Wayne model 6158-V that was given to me free. It needs a tune-up kit, valve discs, valve springs, gasket set, complete piston ring set and oil seal...