Search results

I have a 30x30 garage with insulated walls. Going to insulate ceiling and looking To install a heater, what type should I use and what is the cost of operation etc. I would like to use a radiant tube neater if possible. Any input would be appreciated.

I'm adding a table saw to my "man cave" the shop/garage and I have some concerns about power requirements. The house was built 4 yrs ago and the outlets are wired with 15 amp breakers. With a beer fridge and all the lights on the same circuit I guessing the breaker will trip when the 13 amp...

Has anyone added a pull chain switch to the LED T8 fixtures from Costco. I seen they only pull .38 amp, so I would think a small little 1 amp pull chain switch should work, anyone have any thoughts on this ?

I would like some advice on Romex wire. If the outside jacket on a romex wire in nicked or even torn off in a small area is it ok to use good quality electrical tape and tape of the area that is exposed? The wires individual wires inside the romex are not damaged. Any input will be appreciated.

Can you run 3 sets of 14/3 w ground in a single armored cable ? Total length of run is about 12' Thanks in advance for your input.

I would like to convert a single switch in a bathroom to a 3-way switch. With everything finished and vanity in place can I run the new wire form the existing switch through the back of vanity cabinet using aa flex cable and still meet code? Installing the like this will avoid running through...

I'm fairly new to this forum and have learned a lot but still have some questions. I have a 28 x32 garage with three garage doors. The common wall attached to the house is insulated, the two side walls are insulated [ not sure about a vapor barrier], and the ceiling height is 11' without...

I reading all the input on garage heating etc, has anyone looked into using a in wall heater/ ac unit to heat and cool your garage? It seems like everyone uses the overhead heaters etc, but I would think this would be a noval way to kill two birds with one stone. Also, does anyone know the...