Search results

  1. A

    Updating Dayton Thermostat

    I have two Dayton overhead radiant heaters in my shop. They are controlled with an older style Dayton thermostat (pics attached). I would like to replace this with a digital heat only thermostat. The single thermostat controls both heaters and they auto ignite when the call for heat it applied...
  2. A

    Dayton Infrared Heater Startup Operation

    Hi Guys, I purchased a home this year that has a detached shop with two Dayton Infrared Heaters that hang from the ceiling. The model number is 3E133A. They are 60,000 BTU each. They are run on NG. There is also a Dayton thermostat wired in that is attached to the wall. Each heater has its own...
  3. A

    Turning on Gas to Shop

    I purchased a home in April of this year and it has a detached 30x40 shop. The shop has two large overhead Dayton infrared heaters with natural gas ran to them. The previous owner was an older gentleman who had health problems for a while before he sold the home, so im assuming that he didn't...
  4. A

    Sealing between concrete floor and foundation block in garage

    I’m my detached garage where the concrete floor meets the cinder block foundation there seems to me a small expansion space along the entire wall. In an EXTREMELY HEAVY rain I will get a little moisture/water leaking in through this gap. And yes, I did did dig out around the exterior of the barn...
  5. A

    Bottom Seal Type for Overhead Doors

    I have a 30x40 shop/garage with three overhead doors. One door is standard height and the other two are close to 13ft tall or so. The doors are wooden at the bottom and originally had the kind of seal that you nail/staple on, but they are pretty beat up and needed replaced. similar to this seal...
  6. A

    230v 5HP Compressor Plug/Receptacle

    I just purchased a 230V 5hp Champion 80gal compressor. I currently have a 30 amp circuit ran with 10 guage wire. Can you guys recommend with plug/receptical would be best for this application? After some reading on here, some people say it needs to be hardwired due to no plug being rated for...
  7. A

    Champion Centurion II VRV5-8 Questions

    I am looking to purchase a nice 230V 80gal air compressor for my home shop. I believe I've narrowed it down to a Champion after hours of reading online. I was looking at new compressors and then I thought to check CL and found a Champion Centurion II, with model number VRV5-8. It is new and has...
Top Bottom