Search results

Rust-Oleum states "...apply second coat within one hour or 48 hours..." Can anyone explain this to me? THX

This is an old saw but has really had light use. I've changed the blade several times and it does a pretty good job. Sometimes I cut thin aluminum that creates a lot of filings that tend to stick to the rubber belt(?) on the drive wheel that the blade rides on. The other day the saw blade was...

How much work/effort would be involved in restoring this?

I recently broke 2 Norseman Super Prem Magnum drill bits...T & 3/8" They were virtually new and stupid expensive to individually replace. However it seems when all is said and done it is easier to just replace them. Now what do I do with the one that I broke. Only a slight bit at the tip is...

I did business with this fella previously. How do I get ahold of him? I tried him is search and no luck. THX

I'm going to be building a 21 x 38 inch table for a bathroom. The material is 1/4" 304 stainless with a slightly coarse "mill finish". I do not want to polish it but to just gently remove burrs, scale and any roughness. I'm looking for advise on what tools to use and what products to buy for...

McMstr-Carr has Cobalt coated bits with a tip angle of 130 or 135 degrees. Would these be the best for SS drilling....vs 118 degree? VS- Norseman Drill 3/8" Heavy Duty 6" Length Super Premium 39410? THX

I just got these from amazon. It appears I need some kind of holder. Does anyone have experience with these? THX

This is FS in my area- Asking $200 obo. Is this a good deal? Made is USA. ... ''new old stock'' Biesemeyer T-Square saw fence system w/ rails. Never installed. It's just been sitting in the garage and I never got to install it. No need for it now. As new, just dusty." [/URL][/IMG]

I would like to purchase this from a friend of a friend...he's a great old guy (84) but he has no idea of the value of this machine. Its in an enclosed trailer in his back yard. It is functional. With research I could probably come up with some time buy with all the fire power on this site...

This looks to be a pretty good deal. It has the Biesemeyer fence. Any input? http://atlanta.craigslist.org/nat/tls/4769277846.html Seems used Table saws are pretty soft?

Can anyone shed light on how this is done, cost, how many shops might do this...

I do not wrench for a living but occasionally I feel like purchasing a Snap On tool for a special need or use. They have some great stuff. However, I have found it next to impossible to get the local SO guy to pay any attention to me. Do the local dealer/truck guys ever service folks who are...

This is a 3" V-Band set up. It got ever so slightly warped during the weld up. What is the best way to gently get a perfectly flat surface....Surface Plate with sand paper...chuck it up in a lathe......? THX

Does anyone have one of these or have an opinion on Eastwood tools? Its on sale on Ebay... http://www.ebay.com/itm/231312481294

I just bought this and hooked it up. It is stunning. If you have a shop you need this!

I have several 6062 T-6 .065 wall pieces with bends. Like this- Using this tool I am putting beads on the ends- This has turned out a LOT harder then I thought. If there is any resistance the tube deforms and starts to collapse on its self. Its an learned skill. A big problem is how to...

This machine was purchased used with ~ 91 hours and 21,000 arc starts. It looks a little beat up. I have not used it enough to ensure that the arc start is working properly. http://www.garagejournal.com/forum/showthread.php?t=248049 A close friend is selling this...5 hours total and mint...

I just purchased these. Can someone explain how to read this chart?