Search results

Just another way to bend metal here. http://www.1969supersport.com/sheetmetal.html Rob http://www.1969supersport.com

Heres some pictures if it might help. http://www.1969supersport.com/draw1.html Rob http://www.1969supersport.com

Yeah I do, keeps me busy. Thanks for your comment. Rob An engine hoist and slings will get it done, good one. Thanks for your comment. Rob http://www.1969supersport.com

Home made, on my website under door holder. Rob http://www.1969supersport.com

2nd picture down http://www.1969supersport.com/jigs7.html Rob http://www.1969supersport.com

Do they make trailers that are low enough to go under a regular size garage door, The door is 16' wide but probably under 8'. Rob http://www.1969supersport.com

Your welcome Ed. Rob http://www.1969supersport.com

Ed, me again, one last thing, heres a picture of me in supplied air. http://www.1969supersport.com/restoration.html on page 7. Rob http://www.1969supersport.com

Ed, the garage on the right, over on the left end you will see the exhaust fan vent. http://www.1969supersport.com/robsgarage.html the last picture is the other garage, you can see a blue colored bead blaster that I use, I always have supplied air on when I fill it or clean it or when I'm...

Ed, on page 6 of this http://www.1969supersport.com/paintroom.html you see the pump and hose. I have a raised ranch type house, and I run about 40' feet of supplied air from the bottom level of the house 7' under ground through I think its 4'' pvc out to the garage, then I have another 50' of...

I use it for any rattle canning paint, even small parts, also when I clean out my garage (shop), I use about 130 lbs of air pressure and just blow it out. When you use supplied air, it takes a while to get used to the cord dragging behind you, but once you use it several times, you learn how to...

Heres the unit I use, http://www.sjdiscounttools.com/sas9800-18.html but it also depends on what I'm breathing and how much of it, but I use it for all my grinding and painting and sand and bead blasting. Rob http://www.1969supersport.com

SAS supplied air. Rob http://www.1969supersport.com

Good stuff Steve, just a question, how much air were you running through the lines? Rob http://www.1969supersport.com

If you clean the threads on black pipe with some lacquer thinner and a small wire brush, you can use tape or putty, either one will work okay, I found that out after fighting some leaks, clean the fittings good. I have roughly 170' of 3/4'' black pipe running all over, zero leaks. I was...

Would it be possible for you to show us how you do it, put some pictures of your setup on here, if you have a better way, we can learn something. Rob http://www.1969supersport.com

If you use 3/4'' black pipe and run your air lines right, you don't need an air dryer. I sandblast and bead blast, the last one I did was a 69 chevelle body, floors inside the trunk cowl etc. But I didn't blast the fenders top or hood. I went through 1100 lbs of sand with a eastwood 100 lb...

Heres this if it will help. http://www.1969supersport.com/draw1.html Rob http://www.1969supersport.com

I take Buster every place I go, unless its to hot or to cold while he waits in the car. They are the most loyal and best friend you will ever have. Rob http://www.1969supersport.com