Search results

Is that a hammered blue paint??

I worked on it for a few minutes today with the drill and wire brush. I got close to being able to start the bolt. I think I need to remove the dynamic and get the drive nut out. I’m guessing the hole goes all the way through???? I can’t remember if reeds go through under the dovetail.

At least one goes all the way through. Good idea with the air and vaccum. I'll definitely try that!

Ok thanks! Im not sure if this block has any metal in it or not. I'll have to wand it when i get it off the cabinet. Cutting and regluing will be my last try I think. Thanks on the Dawn. I just got it at another sale. it's my second one.

I wanted to see what you guys thought on this. I have an old cabinet with a butcher block maple top. It's starting to come apart in a couple places. I dont think I can spread some of the cracks any further. What type of glue do you think would be best?? Regular titebond? CA? This would not be a...

I need it to fit under a workbench and the castors are about an inch too high. I may put some type of wood under it to take up the difference. I might have kept them otherwise. They look like run of the mill hardware store castors but the cabinet rolls great! I think I even saw grease fittings...

Thanks to @drivesitfar for this thread and @Private Lugnutz for the info. I got myself a 41-C-15 Cabinet. It has been spray painted gray and needs the welds repaired at the ends of the crossbar under the top drawer. I read everything I could about these and it did not disappoint. It's an...

Very cool! thanks for the info!

Finally landed a swivel base for my Reed 406. Stupidly I didn't even look at the bottom of the vise and couldn't figure out why the swivel bolt wouldn't go in. Any tips on saving these threads would be greatly appreciated! I don't have a tap or thread chaser that big available. Does anyone know...

I'm not very knowledgeable on the Stanley stuff. Hopefully one of the gurus will chime in on this one(y) @Smitty said it's early 40's.