Search results

Had to service my Milwaukee M12 impact 3/8 ratchet. Would like to replace the retaining ring (snap ring) since they lose tension when they are expanded. The parts fiche everywhere shows part #12 but no part number. They are available with the whole assembly but the snap ring is all I need. I...

My painter is on the fritz, not returning calls, and a contractor friend who uses him all the time said that Tue-Sat he is very hard to get a hold of, he turns his phone off or something. He takes calls Sunday afternoon, and Monday then books his week. So that means I will have to prep this job...

Anyone put quartz, stone, Corian, Caesarstone etc onto a well made acrylic type shower pan? Talking 600 lbs total spread out over the pan tiling flanges.

Anyone know what this is called? I have Googled almost every combination and synonym I can think of. It is a clip that holds the chain on a 5 gallon General - US Metal Can (Blitz) - Jerry Can circa 1980's and 1990's before CARB forced EPA to change to plastic caps. It goes thru the chain link...

Thought I would post this in case someone is doing a search. One of my twin devilbiss built compressors has been knocking a bit near the shutoff pressure. Sounds like a rod or diesel knock, a very sharp rapping sound. It was abused by the former owner but has been good to me once I replaced the...

anyone know who made these style craftsman torque wrenches models 31423, 31424, 31425. I have a couple I picked up that are missing the end caps. They are still sold so some parts might be out there if I can figure out who made them. I did find instruction manual but no hints there or part...

came here hoping to find a recommendation on buffing wheels for a 6" 1/2" shaft grinder. Bought several grades from a local hardware, and they throw cotton fibers everywhere. They don't want to take rouge either so I end up slinging red rouge and cotton everywhere when polishing something like a...