Search results

miter saw in very good condition .

100' Lufkin tape rule came in a box of tools I picked up recently .

I have had this for a while. .

Recently picked up at garage sale: Powr-Kraft aluminum rafter square. .

Long C ratchet, BE makers mark. It was gummed up inside, so I took apart, cleaned in spirits and loosely re-assembled for now. Works well. .

thanks all for responses Merlin: I am in Chicago area, so freeze and thaw is constant concern. I would not want to replace just a part of the pier. And digging the pier out would be a pain since it is so close to the patio. Struetang: yes, I am thinking the settling of the pier was due to...

I have a 15 year old small porch roof over the patio doors. The house is 25 years old. One side of the roof has dropped about 1-1/2". I want to level it out, mainly for resale reasons. I think the post concrete dropped over the first few years, the other side seems level from the house. -...

a few items at a nearby moving sale. I wasn't going to buy anything, but once I saw the clamp, I had to add a few more items, total $7: - Chessco metric hex key set - oil seal puller - 4 plastic clamps - Kraeuter wire cutter - magnetic tip - CMan ball pein hammer - 5" C-clamp, I don't...

I think the logo may be Mossberg ?? Anyone need for their set ?? .

what color paint did you use? Looks great.

Hiball: quick update on the Pittsburgh Rapid pump racing jack. I replaced the ram seal/cup, and the pump piston o-rings. Had a slight leak after assembly, needed to tighten up the piston cylinders a bit more. I now know about how much torque these can take (alot). I have had the jack holding...

thanks guys for the suggestions on fixing the bottom drawer rails.

Outlaw: Thanks for replying. The top rail of the c-shaped stamping that is tacked to the drawer is broken about half way back and missing. On the box wall, the mating c-channel bottom rail is a bit tore off, but appears all there.

I finally started on my Heritage logo collection. Decent shape, except for the bottom drawer rails. Both the drawer rail and the box rail on the right side bottom drawer are damaged. Any suggestions on repairing that? Also, I don't see a date code. Will do some lightly cleaning of the...

https://www.searspartsdirect.com/model/4rv9tix8ih-000247 the guard shows up as unavailable, not surprising. But there are some part numbers listed, and a few basic diagrams, for that unit.

nicely done shortyg83 .

Nicely done on the handles.

Thanks FrankLee: that is what I figured.

Does anyone know if any of the parts from the Dunlap drill press (I assume is 12-1/4") are inter-changeable with the CMan 13-1/2" machines? I looked through some Dunlap parts listings, and nothing seemed to be the same, but I know that part numbers can change. There is a Dunlap nearby that I...

quick update on my attempt to replace a seemingly bent spindle. As I had mentioned previously, that spindle is pretty straight all the way up to the arbor itself, and then is either bent or mis-machined, with run-out going from 0.005" to 0.010" just over the length of the arbor itself. I...